Connection point for 3 radials. The hardware is 1/2" stainless. It is in the holes that were made for the rods that were used during erection to keep the stress off the insulator. Between each radial is a flat washer that is dipped in noalox type gunk. There is also more gunk under the washers holding the bolt to the plate.
The feed connection. Same 1/2" stainless hardware and washers. The cable ends are soldered on eyes. The feed cable goes up to a carrier rope that is tied to the first rung of the vertical. I figured that was less likely to stress the connections when the rope/cable are coated with ice than if it was below the insulator. It also keeps the feedline higher off the ground.
View from above..
View from above of another feedpoint..
View 'across the pond'... If only this were the 'big pond'!
The End ... I hope for this year.